Brompton G Line 20 inch front SP PL-7 Hub Dynamo Kit
This is the 20 inch front wheel for the Brompton G Line with an SP PL-7 hub dynamo, this is a kit and includes ll the parts needed to change your G line to hub dynamo lighting
It comes taped ready for tubeless conversion
Key features:
- 32 spokes
- 6mm presta valve hole
- Taped ready for tubeless use
- Single butted spokes
- Double walled rim with clincher
- All black, spokes, hub and rim
- Weight approx 900g
- 100mm OLD hub for center lock disc rotors
- Rim Internal rim 22.6mm
- Rim external 28mm
Brompton Q part code: Q104413
The kit includes the following parts:
- 20 inch SP PL-7 643W dynamo hub front wheel
- Busch and Muller IQ-XS friendly front dynamo light
- Spanninga Solo rear dynamo light
- 160mm centre lock disc brake rotor
- Dynamo warring loom
- Front G line dynamo light bracket
Removal
To remove your front wheel:
- Undo the axle bolt using a 6mm Allen (Hex) key
- Remove the axle bolt completely from the wheel
- Guide the wheel clear of the fork
- Do not squeeze the brake lever while the wheel is out as this will close the brake pads
Fitting
The front the wheel:
- Fit the disc rotor
- Ensure the wheel is the correct way round with the brake rotor ready to fit into the pads on the left had side of the fork
- Guide the wheel in place
- Fit the axle from the righthand side of the bike to thread in place, tighten to 11Nm
- Fit the dynamo light bracket
- Fit the front light
- Route the dynamo wiring loom to allow the rear light to be fed off the front light
- Fit the rear dynamo light to the rack, where the reflector is fitted