Intense main pivot expander bolt 1.0t
This expander bolt is used to mount the Lower box link for Intense alloy frame bikes - 2011 and later (except for M9).
This is the fine thread expander bolt (version 1) later bikes use a coarse thread bolt.
Note: This is the expander bolt only - you may also need the cone adjuster, cone adjuster bolt and main pivot bearing caps if you are replacing everything.
Two of these bolts are used - one for the top and the bottom of the lower link.
This lower box link is for the following Intense frames (2011 and after):
Intense M9 FRO
Intense Tracer 2
Intense Tracer 275 Alloy (2013 and 2014 models only)
Intense Tracer 29
Intense Spider 2
Intense Spider 29
Intense SS2
Intense Uzzi VP
Intense Tazer VP
Intense 951
If you look at the attached manual for the 951 EVO you can see the location of the expander bolt in the exploded BOM diagram
Tools required:
8mm allen key (to remove / install expander bolt - this part)
5mm allen key (to remove / install cone adjuster bolt)
The main pivot expander bolt should be tightened with a 8mm allen key to 7Nm
This part is available as part of a kit: IT340348
Measurements as follows:
- Full length = 76mm
- Width = 15mm
- Head length = 11mm
- Head width = 19mm