Brompton G Line Tektro Disc Kit Right Hand Lever
This is the right hand, front brake lever as installed on the G line Brompton bike.
Installation of these brake calibers and lever should be performed by a qualified mechanic
The following parts are in the packaging:
- Right hand / Front brake lever - TRP
- Hydraulic brake cable
- Brake caliper - FMR
- Flat mount - TRP - FF-5 adapter
- Relevant fixings
Installation as follows:
Installation of the rotor:
- Tools - Torx T25 with torque wrench
- Remove the wheel
- Note the rotation of the wheel
- Ensure the rotation of the rotor is correct
- Attach the rotor to the hub with the supplied Torx bolts
- Tighten in a sequence where the two opposite bolts are tightened first and second, then the following opposite bolts and the third set of opposite bolts
- Tighten all bolts to a final tightness of 4 - 6Nm
- Re-instal the wheel
Installation of the brake lever:
- Tools required - 4mm, 3mmAllen wrench and a torque wrench of 4mm
- Adjust the brake lever to the desired position.
- Tighten the 4mm Allen key bolt to secure the lever in place
- Tighten to 6 - 8 Nm
- You can adjust the reach of the shifter using a 2 mm Allen Key
Installation of the caliper:
- Before insulating the caliper ensure the wheel is correctly seated in the dropouts
- The brake rotor should be on the caliper mounting side
- The flat mount adapter is fitted on the caliper, the bolts should be tightened to 5 - 7Nm
- Make sure the pads are seated correctly - do not tighten the bolts at this stage
- With the caliper mounting bolts still loose squeeze the brake lever
Attaching the hydraulic disc hose:
- Insert the barb
Brompton Q part code: Q103702
The brake pads used are SP10.11, like B05S or P100005052